What would cause my Amana gas furnace to stop working? - amana gas furnace
They have a model of vertical flow AMS80904BNA Amana 80% efficiency gas furnace is not easy.
Code diagnostic LED flashes three times in the heat. Get a buzz after power relay. The induced draft fan motor checks OK, but I'm not the power of the AC. The heating unit has worked well until a 20 A circuit breaker triggered from the oven.
(Note: This is a central heating and cooling unit)
Breaker proved to be old and damaged to be replaced (no difference), the device will not work
They also have great difficulty in a service in the literature of this particular unit.
Thursday, January 21, 2010
Amana Gas Furnace What Would Cause My Amana Gas Furnace To Stop Working?
Subscribe to:
Post Comments (Atom)
4 comments:
They are not likely to find to find documentation on this service and the parts so hard to find.
It is a microprocessor that controls the drive and could not be bad.
Because questions of liability for most companies do not sell parts that go "into" customers. "
The exhaust fan is usually the first to be called, and after the sensor allows the process to continue. If a project within a specified period, the device turns and waits before trying again. If there is no energy in this fan, you need to see if the device out of control. If not, you may need a new control (if you can read about the power goes into the apartment, etc.)
Adjust thermal overload on the drive. Triggered circuit breakers, if the device worked, it was too hot. Blows for the same reason, the fan, after the flame is extinguished. Look somewhere around the burners a red button that must be restored. It can be very low. It is probably a cable running from each end.
Check the switch will test pressure for the project. Even the deployment of security controls, which must be manually reset when triggered.
Post a Comment